EA-01 Basic Air Track
Our Basic Air Track is not mounted on a support beam. The track which is carefully annealed for stress relief is selected for straightness before fabrication and retains this shape throughout its life.All three air track designs use the same specially designed triangular extrusion . We don't settle for a thin wall square section to build the track section.
You may feel that you seen our Air Tracks before. You may have seen them in other major distributer's catalogs. We supply the best of distributers with their Air Tracks. They are made to the same high standards as those we sell. We do offer the widest range of Air Tracks and the most accessories so there is a reason for taking time to see what we have.
Specifications
| Air Track | Gliders | ||
| Working Length | 1.6 m | Mass | 2 300 g &1 150 g |
| Cross Section | 90° Apex isosceles triangle | Springs | 3 2.5 cm stainless steel coil springs |
| Wall thickness | 0.3 cm | Bumpers | Stainless steel |
| Air Holes | Two rows 0.09 cm dia | Magnets | 2 ceramic magnets for non-contact ccollisions |
| Measurement | Full length metric tape & spark paper groove | Manual | Daedalon Air Track Manual |
| End Stops | Bumper Springs, Glider Launcher & End Pulley |
The volume of air used by an EA-01 1.6 m Air Track depends upon the inlet pressure. The volume is given by the equation
V = 169 e-6*P
where V is the volume in cubic meter/second and P is the pressure in kiloPascals. Our Tracks will operate satisfactorily when the pressure is between 5 and 10 kiloPascals.